AutoAnchor 560, Owner'S Manual

Page: 11 / 41

Before starting check with the AutoAnchor manufacturer, or supplier, that it is
SRVVLEOHWR¿WWKHVHQVRUDQGPDJQHWWR\RXUKRUL]RQWDOZLQGODVV
For an accurate rope count the rode must run between the sensor and magnet. On a
horizontal windlass the magnet and sensor must be fitted by the windlass manufacturer.
If it is not possible to have the sensor and magnet fitted to achieve this you can use the
chain only horizontal windlass installation above.
This provides an accurate count of
rode deployed but during retrieval the display may be incorrect because it cannot
allow for the stretch in the rope.
2.1.9 INSTALLATION HORIZONTAL WINDLASS - ROPE & CHAIN
Gap Between the Sensor and Magnet:
Minimum 5mm and maximum 40mm.
7KHPDJQHWDQGVHQVRUPXVWEH¿WWH d so that the gap remains consistent as the
winch turns.
Magnet Installation:
Size: 10mm x 8mm magnet (# ).
The magnet can be mounted on the main shaft or on the side of the drum. See Figs 8 and
9. If mounted on the side of the drum, position it close to the inside to reduce the
peripheral speed of the magnet. Fix the magnet into position with epoxy ensuring it is
completely sealed to prevent corrosion
.
Sensor Installation
The Grey 3 wire AutoAnchor sensor (#9067) is recommended but a proximity sensor may
be used. Every installation is different so this manual can provide guidelines only. The AA
sensor holder # , or a customised sensor holder, will be required to ensure the
sensor remains in position and the gap is consistent between the sensor and magnet
during operation.
2.1.10 INSTALLATION DRUM WINCHES
Sensor Connection:
The AutoAnchor plug and play sensor extension cable must be
used to connect the sensor to the console unit. Ensure the connectors are firmly screwed
together. See the information on page 4.
Loose cable should be tied in place with cable ties and kept clear of chain.
For drum winch set up and operation, refer to page 19.
Magnet
on side of
drum
Magnet
on shaft
Sensor
Sensor
Fig 8 Fig 9
Magnet
Sensor
Fig 7
OD
ID