AutoAnchor 560, Owner'S Manual

Page: 26 / 41

4.3.2 To Check Logs
The AutoAnchor must be turned on.
Press to access the Menu.
Select Logs.
Return to the menu.
Exit and return to start screen.
Logs are cleared using the Factory Default Settings. See page 14.
Resetting the Factory Defaults clears all logs and calibrations.
4.3.4 To Adjust Backlight
The AutoAnchor must be turned on. It is best to change this setting in low light.
Press to access the Menu.
Select Backlight.
Change the Backlighting level.
Save and return to the menu.
Exit and return to start screen.
4.3 OTHER OPERATION SETTINGS
Press to access the menu when the AutoAnchor is turned on.
4.3.1 To Clear to Zero
The AutoAnchor must be turned on.
Press to access the Menu.
Select clear to zero.
Select No/Yes.
Yes
- return to start screen.
No
- return to the menu, then press again
to return to the start screen.
9
10742
112
Clear to zero
Logs
Backlight
Reset sensor
Reset sensor
4.3.5 To Reset Sensor
The AutoAnchor must be turned on.
Press to access the Menu.
Select Reset sensor.
Select No/Yes.
Save and return to the menu.
Exit and return to start screen.
Deploy the anchor to tune the sensor.
See page 21.
Reset sensor
Reset sensor