ZONEMIX
INSTALLATION AND OPERATION MANUAL
5
FRONT PANEL
SIGNAL PRESENCE LEDS
A green LED will illuminate to show a signal is present
on the corresponding audio input or output zone.
The ZONE LEDs will flash green every second when
the corresponding output is muted. A red LED will
illuminate when clipping occurs due to an excessive
input signal or overdriven output. If clipping occurs
reduce the input or output gain settings.
SD CARD CONNECTOR
Input connector for a full size SD card. Maximum
density 2TB.
Consult the
Support of SD cards larger than
32GB
section on page 10 for further details.
Note: Format the card to the FAT32 file system. Use
a full size SD card adapter to support mini or micro
sized SD cards.
OUTPUT ZONE KNOB
Rotate left and right to select the output zone
Pushing the knob will enter Audio Setup mode.
Consult page 9 for more details.
MIX KNOB
Rotate left and right to select the desired input
channel mix for the output zone.
Pushing the knob will enter System Setup mode.
Consult page 9 for more details.
LCD CHARACTER DISPLAY
20x2 blue LCD character display
PRESETS KNOB
Rotate left and right to cycle through the available
presets. Push the knob to select or save the preset.
VOLUME KNOB
Rotate left and right to adjust the volume level of the
currently selected input or output.
Push the knob to mute or unmute.
USB-C CONFIG PORT
Connect to a PC using a USB-C cable to control the
ZONEMIX via the PC Control Software
STATUS LED
This blue LED will illuminate indicating that the
ZONEMIX is on and receiving mains power.
POWER SWITCH
Press the switch up to power on and down to power
off.
1
1
2
2
3
3
4
4
5
6
7
8
9
10
5
6
7
8
9
10
