ZONEMIX
INSTALLATION AND OPERATION MANUAL
19
CONNECTING WALL PANEL CONTROLLERS
Step 1 Wiring and Termination.
Follow the wiring guide section of the manual to connect and terminate the wall panels to the accessory ports.
Step 2 Power on the Zonemix4/8
Step 3 Use the PC software to pair and configure the wall panels
Step 4 Set audio levels
PAIRING THE WALL PANELS TO THE ZONEMIX4/8
Each wall panel must be individually paired with the Zonemix4/8 to function.
Follow these steps to pair the wall panels,
On the wall panels,
1. On the WP10,
Press and hold the TOP LEFT and BOTTOM RIGHT buttons until all the LED’s start flashing every 0.2s. (Press any button on the
wall panel during pairing to cancel the pairing mode)
On the WP4R and WPVOL,
Press and hold the rotary encoder button for 5 seconds until all the LED’s start flashing every 0.2s. (Press any button on the wall
panel during pairing to cancel the pairing mode)
Only have one wall panel or ZMPS in pairing mode at a time
In the Zonemix PC software,
1. Select the “Wall Panels” button in the main window
2. Select any unused wall panel tab
3. Select the “Pair” button
4. The Zonemix4/8 will upload any firmware updates to the wall panel.
The LEDs will rotate anti-clockwise indicating software is being downloaded to the device.
The LEDs with then rotate in a clockwise direction indicating the software is being written.
5. The PC software with then confirm that pairing is complete
6. Name the wall panel using the “Device Name” to identify it in future.
If you forget or don’t know which wall panel is selected, use the “Identify” button which will make the wall panel flash all it’s
LEDs every 500ms.
7. Using the dropdown menu for each button, select the function desired.
Note: the WPBT does not have any configurable buttons and will instead shows the Bluetooth options that can be modified
such as Name and PIN number.
