ZONEMIX
INSTALLATION AND OPERATION MANUAL
6
REAR PANEL
ACCESSORY PORTS
Allows connection of wall panel controllers, paging
stations and audio wall panel inputs.
See
Paging Station and Wall Panels
section on
page 16 for further details.
ZONE OUTPUTS
The ZONEMIX4 has 4 stereo, 4 crossover or 4 mono
balanced line level outputs (Software configurable).
The ZONEMIX8 has 8 mono line balanced level
outputs.
Balanced male 3-pin (3.81mm) euroblock connector.
STEREO RCA UNBALANCED INPUT
A standard stereo RCA female socket for each input.
This is summed to mono inside the ZONEMIX8. The
ZONEMIX4 will maintain the stereo audio path unless
mono output mode is selected.
A -14dB pad can be applied, via software, using the
front panel or PC control software.
XLR MIC/ RCA LINE INPUT, CH1-2
A standard female XLR balanced socket is provided
on each microphone input:
Pin 1 = Signal Ground
Pin 2 = Hot (non-inverting or in phase)
Pin 3 = Cold (inverting or reverse phase)
MIC GAIN
Provides a rear panel input gain adjustment for Inputs
1 and 2.
1
2
3
4
5
GENERAL PURPOSE INPUTS AND
OUTPUTS
Configurable in the PC control software to perform
various actions.
See page 15 for further details.
TONE GENERATOR
Connect any of the EVAC, ALERT, INTRUDER, BELL
and CHIME inputs to the GND input to play the tone.
RS232
3-pin (3.81mm) euroblock connector for connection
to external control systems.
ETHERNET
Ethernet is used to communicate with the device
over a LAN. The supported network speed is
100Base-T. Consult the
Network Setup
section on
page 10 for further details.
POWER INPUT CONNECTOR
Your mixer is powered via a 24VDC 2A universal
power adapter. The power adapter is included with
your mixer. The DC input accepts a 5.5/2.1mm plug
with tip positive and ring negative connection.
6
7
8
9
10
1
2
3
4
5
5
6
7
8
9
10
