AUMA SGM 04.1, Operation Instructions Manual

Page: 31 / 60

Speed REMOTE
Output speed in operation mode Remote for setting the Speed fieldbus = Internal
parameter; Setting range: linear between 0 – 100 % (0 % = min. motor speed, 100
% = max. motor speed); Default value = 50.0 %
Speed fieldbus
= External
In operation mode Remote, the output speed is defined via fieldbus.
= Internal
In operation mode Remote, the output speed is not defined via fieldbus but by means
of the
Speed REMOTE software parameter.
Table 15:
Example values of type range settings SGM/SGMR 04.1/05.1/07.1/10.1
SGM/SGMR 10.1 SGM/SGMR 04.1/05.1/07.1
Operating time
Output drive
[s]
Speed
Motor
[rpm]
Output speed via parameter:
Speed LOCAL
Speed REMOTE
or via fieldbus:
(
Speed fieldbus = External )
Operating time
Output drive
[s]
Speed
Motor
[rpm]
Output speed via parameter:
Speed LOCAL
Speed REMOTE
or via fieldbus:
(
Speed fieldbus = External )
81 133 0.0 % 52 133 0.0 %
32 338 10.0 % 22 314 9.0 %
22 491 17.0 % 16 431 14.0 %
16 675 26.0 % 11 627 23.0 %
11 928 40.0 % 8 863 34.0 %
8 1,350 57.0 % 5.6 1 232 52.0 %
5.6 1,929 85.0 % 4 1,725 75.0 %
4.8 2,250 100.0 % 3.1 2,250 100.0 %
Table 16:
Example values of type range settings SGM/SGMR 12.1/14.1
SGM/SGMR 14.1 SGM/SGMR 12.1
Operating time
Output drive
[s]
Speed
Motor
[rpm]
Output speed via parameter:
Speed LOCAL
Speed REMOTE
or via fieldbus:
(
Speed fieldbus = External )
Operating time
Output drive
[s]
Speed
Motor
[rpm]
Output speed via parameter:
Speed LOCAL
Speed REMOTE
or via fieldbus:
(
Speed fieldbus = External )
– – 0.0 % 275 133 0.0 %
– – 2.0 % 206 186 2.0 %
345 1.1 6.0 % 150 255 6.0 %
240 1.6 11.0 % 103 371 11.0 %
175 2.2 18.0 % 75 510 18.0 %
120 3.2 29.0 % 52 742 29.0 %
95 4.0 38.0 % 41 928 38.0 %
68 5.6 55.0 % 30 1,299 55.0 %
48 8.0 81.0 % 20 1,856 81.0 %
– – 100.0 % 17 2,250 100.0 %
10.8. Cover to controls: close
1. Clean sealing faces of housing and cover.
2. Apply a thin film of non-acidic grease (e.g. petroleum jelly) to the sealing faces.
3. Check whether seal is in good condition, replace seal if damaged.
31
SGM 04.1 – SGM 14.1 / SGMR 04.1 – SGMR 14.1
Profibus DP
Commissioning (basic settings of controls)