19
Operations that can be performed in administrator mode
Setting system information (System Info)
Product setting statuses can be confirmed.
1. Turn the dial button on the Home screen to select “Set” and
then press the dial button.
2. Turn the dial button to select “System Info” and then press the
dial button.
3. Select an item and press the dial button.
Device Name
The name of this product is displayed.
Device ID
The ID number of this product is
displayed.
Serial Number
The serial number is displayed.
FW Version
The firmware version is displayed.
IP Config Mode
Settings for obtaining the IP address are
displayed.
IP Address
The IP address is displayed.
Subnet Mask
The subnet mask is displayed.
Gateway Address
The gateway address is displayed.
Mac Address
The Mac address is displayed.
Dante*
Information regarding Dante is displayed.
Allow Discovery
The settings for automatic discovery by
“Locate” are displayed.
IP Ctrl Port No
The port number of the IP control is
displayed.
IP Ctrl Ntfy
Settings for receiving notifications from
IP-controlled devices are displayed.
Audio Level Ntfy
Settings for receiving notifications from
IP-controlled devices regarding audio
levels are displayed.
M-cast Adrs
The address for multicast is displayed.
M-cast Port No
The port number for multicast is
displayed.
NTP
Settings for the NTP (Network Time
Protocol) are displayed.
NTP Adrs
The NTP server address is displayed.
NTP Port
The NTP port number is displayed.
Time Zone
The time difference from UTC
(Coordinated Universal Time) is displayed.
LINK Status
The usage status for Audio-Technica LINK
Mode is displayed.
LINK Mode
The operation mode for Audio-Technica
LINK Mode is displayed.
No.ofExtension A
The number of connected extensions is
displayed.
No.ofExtension B
The number of connected extensions is
displayed.
No.ofExtension C
The number of connected extensions is
displayed.
No.ofExtension D
The number of connected extensions is
displayed.
* Displayed only for ATDM-1012DAN.
Performing logging settings (Logging)
Perform log message settings.
1. Turn the dial button on the Home screen to select “Set” and
then press the dial button.
2. Turn the dial button to select “Logging” and then press the dial
button.
3. Set each item.
• Functions that can be set are as follows.
Logging
Set whether or not to save log messages.
Destination
Set whether to write log messages to the internal
memory or transfer them to the Syslog server.
Performing preset settings (Presets)
1. Turn the dial button on the Home screen to select “Set” and
then press the dial button.
2. Turn the dial button to select “Presets” and then press the dial
button.
3. Set each item.
• Functions that can be set are as follows.
Recall Presets
Recall saved preset data to change the current
setting.
Save Presets
Save the current settings as a preset.
BootUp Presets
Sets the recalling presets when the product boots.
