CHAPTER 11: IP OUTPUT TAB
11-8
DigiVu
®
Series Multichannel MPEG-2/H.264 Encoder/Multiplexer with QAM &/or IP Output - Installation & Operation Manual
h) Connect another PC or the receiving device to the defined video port at the external switch and set it
up to capture the video over IP as was configured at the ‘IP Output’ tab.
11.13 Stream Settings
11.13.1 Single Program TS:
This feature allows the creation of Single Program Transport Streams (SPTS) from the
IP output rather than all the programs being distributed in a single MPTS multiplex
with a single IP address. This is available to be selected only when the Ethernet output
alone is active. This setting is on the Mux tab. See
“Output Selection:” on page 7-2
to select “Ethernet Only”
.
The configuration
of the addresses, defining the address as multicast and enabling FEC is done in a table available on this IP Output tab. Only
encoders that have been activated on the Encoder Settings tab will be available to configure. For information on that see
“Encoder Settings Tab” on page 6-1.
11.13.2 Enable Constant BR Out:
Configures the multiplexer to output a constant bit stream at a defined data rate without regard to the actual payload data rate.
This may be defined if a STB or other receiving device requires a bit stream at a defined rate. If the payload is less than the
number defined here, null packets will be used to stuff the IP data stream to the defined output rate.
NOTE:
This only works in MPTS mode.
11.13.3 Constant BR: [1000-60000]
This is the CBR bit rate of the transport stream on the Ethernet network if a constant rate is desirable. Defining a bit rate higher
than the payload will result in null stuffing of the transport stream to the bit rate specified here.
Figure 11-12:
Stream Settings Section
Figure 11-13:
Enable and Configure SPTS Feature
