SW5502C
Wireless Serial Server
User Manual
Link modes and
Applications
5.2.6
TCP Client Application: Configure SW550XC as a Pair Connection Slave
A Pair Connection Slave
application
is
configured
for SW550XC under TCP Client Link
.
It is necessary to pair up
with a Pair Connection Master
as described in previous section
.
Please setup a Pair Connection Master
on another
SW550XC device first before proceeding
.
Please follow the following steps to enable Pair Connection application
and set this SW550XC device as Slave in TCP Client Link Mode
.
Figure 5.14
Pair Connection Slave Application in TCP Client Link Mode
Follow steps in
Paragraph 5.1.2 above to configure SW550XC in TCP Client Link
Mode properly
.
Click on the drop
-
down list of the Application option under TCP Client section and switch to
“
Pair
Connection Slave
”
to enabled Pair Connection application in SW550XC
.
Enter the Destination IP address
and the Destination Port number
(
for Destination 1 and
(
optionally
Destination 2
))
that match to the settings of Pair Connection Master
(
another SW550XC device
)’
s IP and
port number that were setup previously
.
Scroll down to the bottom of the page and click on
“
Save & Apply
”
button to save the changes
.
5.2.7
TCP Server Application: Enable Reverse Telnet
Reverse Telnet application is useful if a Telnet program is used to connect to SW550XC and the serial interface of
the SW550XC is connected to a Terminal Server
.
Telnet programs in Windows
/
Linux operating systems require
special handshaking to get the outputs and the character formatting to show properly
.
SW550XC will interact with
those special commands
(
such as CR
/
LF commands
)
if Reverse Telnet is enabled
.
Figure 5.15 shows a
configuration of Reverse Telnet application in the TCP Server Link Mode
.
Note that the Reverse Telnet application
is only available when SW550XC is configured as TCP Server Link Mode
.
Please follow the following steps to enable
Reverse Telnet application under the TCP Server Link Mode
.
