SW5502C
Wireless Serial Server
User Manual
Getting Started
SW550XC in the Hardware Installation Guide
.
3.
Plug the power source to the unit, starting from the ground
(
It is a screw close to the power terminal block
.)
and then the 3
-
Pin power terminal block on the power panel in Figure 3.
A recommended power adapter
(
such as US315
-
1212 power adapter listed in
with 3
-
Pin terminal block can be connected to the
power terminal block
.
You will hear a long beep with all LEDs turn on and after a few second you will hear
a shot beep twice and the RUN LED will start blinking slowly
.
If the device
’
s wireless interface is working
properly, the WLAN LED will also turn on and start blinking once in a while
.
Device
’
s STATUS LEDs will also
start running too from bottom LED to the top LED
.
4.
Note that although internal grounding has been done inside, in order to ensure overall maximum
performance and protection of your device it is strongly advised to properly connect the grounding
.
Please
choose only one of the grounding connections either connecting the ground to the screw on the power
panel or to the Frame Ground
(
F
.
G
.)
pin of the 3
-
Pin terminal block
.
5.
Place the device in the desired location, which is dry and free from dirt or corrosive vapors, and connect it
to a LAN via an Ethernet cable with an RJ45 connector
.
6.
Connect your computer to the LAN network
.
Default configurations will be addressed later in Chapter 3.7
below
.
Note
1
:
Please consult your Hardware Installation Guide
(
leaflet available in your package
)
for more information when attempting an
installation
.
Also, please follow all safety procedures when doing so
.
