Atlona AT-UHD-PRO3-1616M, Manual

Page: 11 / 79

AT-UHD-PRO3-1616M 11
Panel Description
1 HDBaseT OUT
Connect up to 16 PoE-compatible receivers to these ports using Ethernet cable.
2 HDMI IN
Connect up to 16 HD/UHD source devices to these ports using HDMI cables.
3 HDMI OUT
Connect up to four HD/UHD source devices to these ports using HDMI cables.
AT-UHD-PRO3-1616M
FCN CANCEL EDID INFO
POWER ENTER 5 6 7 8
1 2 3 4
HDBaseT OUT
1ED 2ED 3ED 4ED 5ED 6ED 7ED 8ED 9 10 11 12 13 14 15 16
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
17 18
19 20
HDMI OUT
AUDIO OUT
1
L R
2
L R
3
L R
4
L R
5
L R
6
L R
7
L R
8
L R
9
L R
10
L R
11
L R
12
L R
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 1
2
3 4 5 6 7 8
IR OUT IR IN
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
IR IN RS-232
MAIN
RX TX S LAN FW
OFF
ON
PWR: 100-240VAC 50/60Hz
HDMI IN
9 10 11 12 13 14 15 16
2 3 1
4 5 6 7 8 9 10 11
Rear
4 AUDIO OUT
Connect these ports to the analog inputs of a DSP, audio amplifier, or other output device, using the included
4-pin captive screw blocks. Refer to Audio Connectors (page 13) for wiring information.
5 IR IN
Connect a control system to these ports. Refer to IR Control (page 54) for more information.
6 IR OUT
Connect IR emitters to these ports, in order to control source devices. Refer to IR Control (page 54) for more
information.
7 LAN
Connect an Ethernet cable from this port to the Local Area Network (LAN).
8 FW
Connect a USB to mini-USB cable from this port to the USB port on a computer, when performing a firmware
upgrade. Refer to Updating the Firmware (page 70) for more information.
9 MAIN (RS-232 / IR IN)
Connect a control system to this port using the included 5-pin captive screw block. Control can be performed
using either RS-232 or electrical IR. Refer to RS-232 Control (page 49) and IR Control (page 54) for more
information.
10 ON/OFF
Press this button to power-on or power-off the matrix.
11 PWR 100-240VAC 50/60Hz
Connect the included power cable from this receptacle to an available AC power outlet.
NOTE: By default, HDMI OUT 17 - HDMI OUT 20 are used for mirroring: ZONE OUT 8 follows
ZONE OUT 7 and ZONE OUT 10 follows ZONE OUT 9 . These two HDMI output ports can also be
configured to receive any one of eight HDMI input signals, allowing the unit to function as an 8 x 10
matrix switcher. Refer to Output Mirroring (page 29) for more information.