Operating instructions SunCool
TM
- 12 -
Figure 5
4
Start-up
1
Plug at the rear side of the unit.
2
Plug at the bottom of the unit.
1
2
4.1
Checking the trough plug
The condensate forming during the operation of the unit is
collected in a trough at the bottom of the unit. The con-
densate evaporates during normal operation of the unit.
A plug at the trough prevents the water from escaping.
Before the initial operation of the unit, make sure that the
plug is installed.
Version A:
The plug
1
is located at the rear side of the unit.
Version B:
The plug
2
is located at the bottom of the unit.
Figure 6
OPERATION
OFF
ON
THERMOSTAT
WAIT 3 MINUTES BEFORE RESTARTING
3
1
5
7
9
11
COOLER
FAN SPEED
LOW
HIGH
4.2
Visual inspection
Prior to the installation of the unit, check to see if the refri-
gerant circulation system is working properly. There must
be no coolant leakages.
WARNING - Health hazard:
Contact with refrigerant may cause injuries to
the skin and to the mucous membranes.
Avoid contact with refrigerant. Wear protecti-
ve gloves and discard escaped refrigerant as
special waste.
•
After contact with refrigerant, rinse refrigerant off with
plenty of running water.
•
After a refrigerant leakage, do not operate the unit and
contact Technical Service.
