23
4. Move the lift about 3' from either the top of bottom of
the rail. After 30-seconds the beep indicating that the
lift is not positioned on a charge point. The beep will
stop after 30-seconds.
5. Test the seat swivel at the top using the levers and
swiveling the seat towards the landing and stop the
seat at 35° and 85°. The seat swivel levers will release
into a locked position at each of these angles. The lift
will not operate in any of these positions if the control
switch is pressed. Return the seat to its normal
position and the lift will now operate normally.
ADDITIONAL SYSTEM CHECK
1. After the successful testing of all safety switches,
sit on the lift and operate to the top of the stairs.
Keeping the control switch pressed continuously,
the lift should gently decelerate and then stop at
the top of the rail.
2. As a final adjustment, sit on the lift and do two (2)
complete up trips and stop with the chair at the
bottom. Then tighten the compression screw in the
top end plate, then run the chair to the top and again
tighten the compression screw. Run the chair to the
the middle and do a final tightening of the
compression screw.
3. Drive the lift to the bottom, keeping the control switch
pressed all the time, and check that the lift gently
decelerates and stop so the footrest pan is clear of
the floor. If necessary adjust the limit cams with a
5/64" Allen wrench.
RAVE 2 INSTALLATION MANUAL COMPLETION PROCEDURES
