13
FOOTREST AND SEAT INSTALLATION
1. Remove the footrest from the
box and use the installation
switch to drive the chassis
downward to a position about
6" clear off the floor. This will
provide a safe area to install
and adjust the footrest.
Do not drive the unit into
bottom stop.
See Figure 4-23.
2. Turn the red "On/Off" switch located on the top of the
chassis to the "Off" position.
3. Position the footrest onto the two (2) seat-leveling bolts
on the outside of the chassis by aligning the large
opening at the slot ends of the footrest.
See Figure 4-24.
4. Ensure that the footrest is fully engaged.
5. Check that the height of the seat base is correctly set for
the intended user. A seat height guide is provided behind
the plastic footrest shroud. Consult with the client and
use an existing chair or walker with armrest as a guide.
If the height of the seat needs to be adjusted, loosen and
remove the four (4) bolts on the sides of the seat base
using a 7/16" socket. Adjust the seat base up or down
relative to the footrest structure until the holes align, then
replace and securely tighten the four (4) bolts.
See Figure 4-25.
RAVE 2 INSTALLATION MANUAL INSTALLATION
