o
Bypass:
clicking on the bypass button will instantaneously bypass the compressor-limiter.
o
Soft Knee:
if the soft knee button is pressed, the a soft knee will be applied to the
compressor-limiter instead of a hard knee.
o
Compressing:
this will indicates if the compression is acting or not.
o
Limiting:
this will indicates if the limiter is acting or not.
o
Ratio(Comp)x:1:
here you can specify the compression ratio either by using the slide bar,
arrow key or by entering directly the value in the dedicated cell. Note: this parameter will
have no action if the filter type is set as limiter.
o
Ratio(Limiter)x:1:
here you can specify the limiter ratio either by using the slide bar,
arrow key or by entering directly the value in the dedicated cell. Note: this parameter will
have no action if the filter type is set as compressor.
o
Threshold (dB):
here you can specify the threshold level from where the limiter or
compressor will start acting.
o
Threshold range (dB):
here you can specify the range of level, in which the ratio
gradually alters from 1:1 to the value set by the ratio parameter (soft knee function)either
by using the slide bar, arrow key or by entering directly the value in the dedicated cell.
o
Response time (10ms):
here you specify the attack time for the compressor-limiter.
o
Recovery time (10ms):
here you can specify the release time for the compressor-Limiter
o
Gain reduction (dB):
indicates the current amount of gain reduction.
o
Graphic:
by clicking on the graphic button, this will open the Compressor-Limiter graphic
edition window, see below. You can adjust the limitation ratio by moving the red cursor,
the limiter threshold level and compression ratio by moving the upper blue cursor and the
limiter threshold range with the upper yellow cursor. You can adjust the compressor
threshold level by moving the lower blue cursor and the compressor threshold range with
the lower yellow cursor.
Ateïs International
Ch. du Dévent, 1024 Ecublens, Switzerland.
Phone : +41 21 881 25 10
128
