PRINTING REPORTS
You can connect a TI 700 or equivalent 1200-baud serial
printer to the serial i/o port of the MERLIN II Attendant to
produce reports to analyze call traffic patterns or to see
how routes, announcement times, or business schedules
are programmed.
NOTE:
A special
adapter is required to connect a “silent
700” printer.
Setting the Baud Rate
The default baud rate for the serial i/o port is 9600. To
connect a TI 700 or equivalent 1200-baud serial printer,
set the baud rate to 1200 using the following procedure:
1
2
3
4
5
6
Dial the MERLIN II Attendant extension from a
Touch-Tone phone, preferably a single-line set.
NOTE:
If you are programming from a multiline
Touch-Tone phone connected to a
MERLIN II system control unit, you must
enter an additional pound (#) sign each time a
pound (#) sign appears in a programming
command.
Wait for an answer.
Dial * followed immediately by the authorized caller
code and #
The
two-beep confirmation tone sounds.
Dial *291712# to change the baud rate to 1200 baud.
The
two-beep confirmation tone sounds.
Continue programming or exit authorized caller mode
by dialing *#.
To disconnect, dial #.
Troubleshooting 3 - 5
Summary of Contents for MERLIN II Attendant
Page 1: ...AT T MERLIN II COMMUNICATIONS SYSTEM MERLIN II Attendant Installer s Guide...
Page 21: ...FIGURE 1 4 Connecting the MERLIN II Attendant Connecting the MERLIN II Attendant 1 17...
Page 33: ...FIGURE 2 2 Supervised Transfer process 2 12 Programming Features...
Page 35: ...FIGURE 2 3 Immediate and Backup Call Handling 2 14 Programming Features...
