5
6
7
8
9
10
11
Repeat steps 1 through 4 for each MERLIN II
Attendant port.
Place the MERLIN II Attendant on a table or desktop
or mount it using the mounting bracket:
CAUTION:
To avoid internal damage and feature
malfunction, do not stack multiple MERLIN II
Attendants.
a
Using a #10 or smaller screw (wood, sheet metal,
concrete), attach the wall mounting bracket to a
vertical wall surface so that the hook end of the
bracket is down.
b
Locate the keyhole opening on the underside of the
MERLIN II Attendant with the hook on the
bracket. Slide the unit over the hook and down to
secure.
Make sure setup switches 1 and 2 are off, then plug one
end of the modular phone cord into the jack on the
back of the MERLIN 11 Attendant labeled “to line.”
(See Figure 1-3.)
Plug the other end of the modular phone cord into an
administered MERLIN II Attendant port on the Basic
Telephone (012) Module. (See Figure 1-4.)
Plug one end of the power cord into the 10 VAC power
connector on the MERLIN II Attendant.
Plug the other end into a 120 VAC outlet.
The power light goes on. If the battery light flashes, routes have
not been programmed.
Reset the setup switches as described in Table 1-5.
Connecting the MERLIN II Attendant
1-15
Summary of Contents for MERLIN II Attendant
Page 1: ...AT T MERLIN II COMMUNICATIONS SYSTEM MERLIN II Attendant Installer s Guide...
Page 21: ...FIGURE 1 4 Connecting the MERLIN II Attendant Connecting the MERLIN II Attendant 1 17...
Page 33: ...FIGURE 2 2 Supervised Transfer process 2 12 Programming Features...
Page 35: ...FIGURE 2 3 Immediate and Backup Call Handling 2 14 Programming Features...
