31
POSITIONING OF THE APPLIANCE
Place the appliance in the position you have chosen and level it by lowering or raising the adjustable
feet.
WATER CONNECTION
The appliance installation requires the connection of hydraulic flexible pipes, supplied together with
the appliance and in particular:
3/4" water supply hose GAS;
Ø 40 mm drain hose.
Connect the drain hose of the appliance to a suitable drain waste system, through a siphon on the floor
near the appliance itself. Connect the filling pipe with a 3/4 "GAS water supply protected by an
interception valve, where a fine filter should be placed in order to catch suspended particles.
ATTENTION
: If the dishwasher is pre-set for being connected to hot water at 50°C, the appliance
must in any case have two water fillings: one for hot water and the other for cold water.
Stick the seal (2)
Connect the drain hoses (8)
Place the units together (3)
Insert the
edge
covers(4)
Connect the appliance to the
equipotential system (7)
Fix the lower
part of the units
together with
screws (5)
Connect the cables (6)
Connector bracket
Remove the frontal panels (1)
