19
MK20HD PLUS / MK20W
English
IR REMOTE
The MK20HD Plus and MK20W come equipped with a remote control which can be used to remotely
control the cameras. Check out the following points before using the wireless remote control.
● Point the wireless remote control at the unit’s wireless remote control IR sensor areas (shown in the
figures), and operate it within a range of 10 meters (32.8 ft) from these areas.
● The signal sensing distance is reduced if the angle at which the wireless remote control signals are
sensed is increased.
The signal sensing sensitivity is approximately halved at an angle of 40 degrees from the front of the
signal light sensing area.
If the remote control is operated from the behind the unit, it may be either difficult or impossible to
perform the desired operations.
● If the unit is installed near fluorescent lights, plasma monitors or other such products or if the unit is
exposed to sunlight, the effects of the light may make it impossible for the unit to be operated using
the wireless remote control.
Be sure to follow the steps below for installation and use.
● Take steps to ensure that the light-sensing area will not be exposed to the light from fluorescent lights,
plasma monitors or other such products or from the sun.
● Install the unit away from fluorescent lights, plasma monitors and other such products.
