T3-OPX installation
T3-OPX User Guide
23
b.
Notice the rotation of the actuator. The “motor” should be facing inwards and the
hole at the bottom of the actuator should line up with the black plastic mount.
c.
Secure the actuator by pushing in the pin. Secure it with the pin on the end.
7.
Install the actuators onto the bracket system.
a.
Place the three metal actuator rods in the top bracket.
b.
Move the T3-OPX unit so each metal rod can fit into each actuator.
c.
Push the metal rod into the actuator. There may be some resistance pushing it
through the plastic fitting at the top.
d.
Screw the metal rod in place. Depending on the padded surface the system is
resting on, the metal rod will most likely hover slightly over the top bracket. This is
normal and a part of the safety system.
Summary of Contents for TrojanLabel T3-OPX
Page 1: ...U S E R G U I D E...