Printing on uneven surfaces (die-to-die overlap feature)
T3-OPX User Guide
70
5.
Select
Apply nozzle alignment settings
.
6.
The process is complete. Remember to insert the value of 0 when restoring the
alignment.
Note:
The functionality involves updating the actual nozzle alignment within the
printhead. This means that the feature requires a recalibration of the nozzle alignment
every time and is therefore not a part of the Media Profile (in media settings).
Consequently, adjusting the die-to-die overlap will affect all media profiles.
Individual die-to-die alignment
To adjust the individual die-to-die overlaps, select
Use individual die-to-die overlap settings
.
It is recommended to print the “die-to-die alignment chart” to evaluate if this is needed. Note
that the print is the full width of the print bar, so if the media is not as wide, it is recommended
to put a piece of paper underneath to avoid printing directly on the table and belts.
1.
Ensure the nozzle alignment chart is printed and successfully scanned.
2.
Print the “die-to-die alignment chart” (
Diagnostics > Print Nozzle Alignment Plot
).
Summary of Contents for TrojanLabel T3-OPX
Page 1: ...U S E R G U I D E...
