Astro Machine AstroJet L1, Operator'S Manual

Page: 60 / 86

SECTION 4
MAINTENANCE
54
Replace Printhead Cartridge
1. Open Top Cover. From the Touchscreen, tap
“Service”
in the Menu drop-down, then tap
“System Deprime”
. The Printer pumps any ink
in system back into Tanks. Then the Printhead
Latch pops open.
CAUTION
DO NOT PRY OR MANUALLY LIFT
PRINTHEAD LATCH OR LATCH
MAY BREAK. ONLY OPEN LATCH
USING THE RELEASE PRINTHEAD
COMMAND ON THE
TOUCHSCREEN OR IN THE
COMPUTER TOOLBOX.
2. Make sure the Printhead Latch is fully
opened to retract ink lines. Remove used
Printhead Cartridge by tilting it toward ink
lines, then carefully lifting it out of the
Printhead Compartment.
3. [A] Carefully remove Printhead
Cartridge from foil packaging
. Tear foil
at notch or cut the end with scissors.
[B] Remove protective plastic cover.
Hold Printhead by handle and unclip cover
from Printhead.
[C] Remove protective strip from
Printhead electrical contacts
. Once
removed, DO NOT allow strip to touch
electrical contacts.
[D] Remove protective strip from Printhead
Nozzles.
Hold Printhead by handle. Pull strip
tab and slowly peel strip from Printhead.
DO NOT pull strip at less than a 45° angle
from Printhead surface.
DO NOT allow removed strip to touch
Printhead Nozzles.
NOTE: Keep foil packaging to store/dispose of old Printhead Cartridge.