Astro Machine AstroJet L1, Operator'S Manual

Page: 20 / 86

SECTION 2
INSTALLING PRINTER
14
Install Over Network Connection, Version B
Use this procedure to install the Print Driver over the Network connection on Static IP systems requiring that an IP
address is assigned manually. NOTE: Copy the 12-digit Hardware ID number listed on the Printer(s) on the
label just below Ethernet port so you can identify the Printer(s) in a later step. NOTE: This procedure can
also be performed from the Touchscreen or Toolbox.
1. Touchscreen: In
“Menu”
,
tap
“Service”
. On the Service
screen, tap
“Network
Config” . The “Network
Config” screen opens.
Uncheck the DHCP button.
You or your IT person can
enter the necessary
information under
“Network
Configuration” .
Tap
“Submit”
.
Toolbox: Install the Printer
Software over a USB
connection using a nearby
computer or laptop. Once the
Driver and Firmware are
installed on the Printer, use
that same computer to open
the
Printer Toolbox .
In the
“View”
drop-down
menu, click
“Service
Menus”
. When the Diagnostic screen opens, click
the
“System Settings”
button.
The
“System Settings”
screen opens. Uncheck the DHCP button. Your IT support person can fill in the
necessary information under
“Network Settings”
( or you can get it from them .) Click
“Submit”
.
NOTE: Disconnect the USB from the local computer or laptop. If not using that computer for printing, the
S-Series Software can be uninstalled.
2. Connect the Ethernet cable to the Ethernet port and rerun
the
“Install Over Network Connection, Version A”
procedure. The Printer should now appear on the
“Printer s Discovered”
window. The Printer can still be
identified by its
“Hardware ID”
, but the new IP address
entered by your IT support person ( or operator ) is shown.
Select the desired Printer and click
“Next>”
. Follow the
remaining steps.