Symptoms
Possible Causes
Solutions
look at the check valves
to see for any obstruction
or stuck valve
3. If you are using shut
off valves for the supply
lines verify they are fully
open.
4. Possible issue with the
thermostatic valve
contact the mfg
Not enough pressure for
body jets, showerhead or
shower wand
1. Verify your line
pressure is 60-80 psi if
not consult a plumber
about the possible
addition of a booster
pump.
2. Verify the diverter is in
the proper position not
half way in between 2
locations
3. Clogged or dirty flow
restrictor
4. Clogged or dirty jets,
showerhead or shower
wand
1. Low water pressure
consult a plumber about
the possible use of a
booster pump.
2. Turn the diverter valve
to the correct location
you will feel a click for
each location.
3. Remove and clean the
flow restrictor and
replace.
4. Clean dirty body jets,
showerhead or shower
wand with mild vinegar
and water solution
Leaks from Jets
1. Loose jet faces
2. Loose hose
1. Remove and reinstall
jet face
Showerhead, jets or
shower wand clogged
1. Sediment or mineral
build up
1. Remove clogged
element and flush and
clean with a mild solution
of vinegar and water
Door seal leaking
1. Misaligment of gasket
seal
1. Adjust the door seal
see the section “Installing
the Doors” for the
procedure to adjust the
door seal
Bath tub Fill not working
1. No water from the bath
tub fill spout
1. Divert MUST be
located on the
Showerhead location.
2. Verify all plumbing
connection
48
