1. The shower wand hose has two tapered ends. One end has an O-ring around
the outside. This o-ring indicates the end of the hose with the vacuum break
diaphragm, used to prevent potential back flow and contamination of the
drinking water. Install the end of the hose with the o-ring onto the outlet spout
for the shower wand located on the wall of the unit.
2. The remaining hose end goes onto the shower wand. Install the rubber gasket
provided between the hose the shower wand.
3. Place the shower wand into the wand holder.
1.Unpack the mirror and inspect for damage. If it is broken or damaged,
please contact your dealer or the manufacturer.
2.Based on your model the mirror may or may not have an orientation. Please
note this when installing the mirror.
3.Remove the protective covering from the double-sided tape on the back of the
mirror.
4.Align the mirror into its intended location while also aligning the screw holes
located at the top and bottom of the mirror.
5.Press the mirror into place. The double-sided tape will hold the mirror in place.
6.Install the screws and soft rubber washers provided. A little sealant around the
screw hole will help seal this hole against any leaks.
WARNING:
Do not over
tighten the screws as this can break the mirror.
7.Install the decorative cap onto the screws.
Step 12 Install the shower wand and hose
Step 13 Install the mirror
29
