tube and back plastic washer on the door roller.
5. Taking one of the doors, with the two holes for the door handles located so
that they are in the center of the door opening, slide the door over the top
two-door roller mounts.
IMPORTANT:
The plastic tubes must be inserted into
the two top mounting holes in the door.
6. Reinstall the plastic washers onto the top roller and then install the metal
locking nuts. Hand tighten the locking nuts.
7. Repeat the process on the two lower roller mounts ensuring that the plastic
tubes are inserted in the glass door and then reinstall the plastic washer and
metal locking nut and hand tighten.
8. Repeat the process on the other door. Only hand tighten the metal locking
nuts.
9. After both doors are installed, close both doors.
10. Check the door seal down the length of the seal. If it is not in full contact, use
a flat head screw driver and adjust the top roller mounts so that the door seal
is in contact for the entire length of the door.
NOTE:
A cam roller inside of the door roller is used for adjustments of the door. By
turning this cam, you will raise or lower the door by adjusting the seal.
11. After making the final adjustments, tighten all of the metal locking nuts.
12. Install the decorative nut covers.
13. Install the vinyl door “F” type seals on each door so that the squeegee flaps
will wipe the glass when opening and closing.
26
