WARNING:
Any final electrical connections must be to a GFCI protected circuit
and made by a certified electrician.
Based on your unit you may or may not have to connect the main control box to
the electrical disconnect terminals.
If you need to connect the main control box to the electrical disconnect terminals,
then insert the connection wire into the disconnect terminal provided. The
connection terminals may be located on the top of the ceiling. If so, insert the
connection wire through one of the access holes located in the ceiling.
You will have to connect the whirlpool bath power connections using the same
assembly procedure as described above locate the connection box and insert the
connection cable.
Connect the signal wires
1.Connect the control panel to the main control box. Use the two 25-pin
connectors provided - they are different genders matching the corresponding
cable to the connection points.
2.Connect the temperature probe to the main control box with the 2-pin
connector provided.
3.Connect the speakers, light, and exhaust fan to the main control box using the
cable provided. You will need to put this cable through one of the access holes
located in the ceiling in order to make this connection.
4.Unwind the antenna built into the main control box and stretch it out to get the
best possible reception. The top of the ceiling is a good location for this
antenna. You can use the existing screws to hold the antenna in place.
5.Optional auxiliary input
- if you want to use an auxiliary audio input such as
an MP3 player or CD player make this connection using the auxiliary RCA
jacks provided on the back of the unit.
IMPORTANT: The final electrical supply connection must be made by a
qualified electrician in order for the warranty to be valid.
Step 18 Electrical connections
32
