© Associated Research 2017
71
LF?
Lists the file name of the memory loaded into active memory (RAM).
LFN?
Lists the memory number of the active memory file loaded into active memory (RAM).
LF <memory number>?
List the file name of any of the 50 memories.
LP?
Lists the prompt that is created for the selected step within active memory (RAM).
LP <step number>?
Lists the prompt that has been created for a particular step of the file within active memory (RAM).
LS?
Lists all the parameters for the individual step that is currently selected. See the ADD command for the list of parameters.
A comma (,) will separate each parameter and will be preceded with the step number.
LS <step number>?
Lists all the parameters for the individual step indicated by step number = 1-30. See the ADD command for the list of
parameters. A comma (,) will separate each parameter and will be preceded with the step number.
IEEE 488.2 Common Commands
These commands are required by the IEEE-488.2 standard with the exception of *PSC, *PSC?. Most of these commands are not
available over the USB/RS-232 bus except for the *IDN? command which can be used to retrieve the instrument identification
information, and the four status reporting commands *ESR?, *ESE, *ESE? and *STB?
COMMAND
NAME
VALUE
*IDN?
Identification Query
Associated Research Inc., Model Number, Serial Number,
Firmware Revision
*RST
Reset Command
Resets HYAMP
*TST?
Self-Test Query
00H=OK
01H=TEST EEPROM ERROR
*CLS
Clear Status Command
Clear Standard Event Status Register
Clear Service Request Register
*OPC
Operation Complete Command
When all selected pending operations complete, ESR
BIT0=1
*OPC?
Operation Complete Query
When all selected pending operations complete, Output
Queue=1
*WAI
Wait-to-Continue Command
*PSC {1|0}
Power-on Status Clear Command
1 = Power-on clear enable registers
0 = Power-on load previous enable registers
*PSC?
Power-on Status Clear Query
*ESR?
Standard Event Status Register Query
0 - 255
*ESE <value>
Standard Event Status Enable Command
Value = 0 - 255
*ESE?
Standard Event Status Enable Query
0 - 255
*STB?
Read Status Byte Query
Read Status Byte
*SRE <value>
Service Request Enable Command
Value = 0 - 255
*SRE?
Service Request Enable Query
0 - 255
