s t e p 1
REAR WHEELS AND TIRES
Make a 1/8" hole in the #7803 or 7804
wheel.
Make sure the #7880 foam insert is
centered in the #7824 or 7825 tire.
Install the tire onto the wheel. Glue the
tire to the wheel with cyanoacrylic glue
in four spots around the tire on both
sides. WARNING: Follow the
adhesive instructions for proper use
and safety. Wear eye and hand
27
5
FRONT WHEELS AND TIRES
Make a 1/8" hole in the #7842 or 7843 wheel.
Make sure the #7880 foam insert is centered in
the #7877 or 7878 tire.
Install the tire onto the wheel. Glue the tire to the
wheel with cyanoacrylic glue in four spots around
the tire on both sides.
Insert the #3977 bearings into both sides of the
front wheel.
Install the wheel assembly onto the axle. Thread
on the #6222 locknut.
Finish the second front wheel and tire.
6
B A G P
REMOVE THESE
PARTS FOR:
Step 2
#6155, qty 1
GT spoiler
T O O L S U S E D
s t e p 2
7880
3438
7842
TEAM BUILT: 7843
7880
7877
TEAM BUILT: 7878
3977
6222
BODY MOUNTING
Trim the #6155 body where shown.
Mask off your design and spray-paint
the inside of the body with Lexan-safe
paint such as Pactra. (Other paints
may not adhere to the Lexan.)
Cut openings in the body where
shown.
Remove, trim and paint the Lexan
spoiler.
Attach the spoiler to the rear as
shown with two #6919 screws and
#6222 locknuts.
Secure the body to the chassis with
four #6332 body clips.
#6332, qty 4
body clip
#6919, qty 2
4-40 x 5/16 screw
#6155, qty 1
Pro-Line GT body
.050"
6155
#6222, qty 2
nylon locknut
6222
6919
1:1
1:1
Put "V" grooves
toward outside
FRONT TIRE
protection.
Install the wheel assembly onto the axle, lining up
the roll pin with the slot in the wheel. Thread on
the #3438 locknut.
Finish the second rear wheel and tire.
7803
TEAM BUILT: 7804
7824
TEAM BUILT: 7825
The tires in your kit may vary from those shown in the photos. Associated is constantly working to upgrade
the kit and if we find tires that we feel are better, we may change to them.
