B A G M
REMOVE THESE
PARTS FOR:
Steps 3-4
T O O L S U S E D
6932, 4145*, qty 4
4-40 x 5/16 screw
1:1
1/16", 3/32"
s t e p 3
THROTTLE/BRAKE SERVO
INSTALLATION
Mount the #7527 throttle servo mounts to the
chassis with four #7673 (6933*) screws. The
small extensions on the side of the mounts
face toward the chassis edge.
19
6936, qty 4
washer
1:1
7527, qty 2
throttle servo
mount
7673, 6933*, qty 6
4-40 x 5/16 screw
1:1
7528, qty 1
antenna/receiver
mount
6727, qty 1
servo tape
3720, qty 4
tie wrap
(wire tie)
s t e p 4
MOUNT RECEIVER
Stick on the small rectangular piece of #6727 servo
tape to the #7528 antenna/receiver mount.
Feed your antenna wire up through the bottom of
the mount.
Stick your receiver onto the mount.
Mount your receiver assembly to the chassis with two #7673 (6933*) screws.
Add two large #3720 plastic wire ties around the
receiver and mount. Tighten down and snip off excess.
Feed your antenna wire through
your #6338 antenna tube. Insert
the tube into the mount where
shown. Add the black #6338 cap
to the top of your antenna.
Now take your throttle
servo and mount it in
between the two
#7527 throttle servo
mount with four #6936
aluminum washers
and four #6932
(4145*) screws. Make
sure the output shaft
is to the rear when the
servo is mounted.
6932, 4145*
7527
6727
3720
7528
7673,
6933*
6936
throttle
servo
faces edge
of chassis
receiver
receiver
antenna wire
7673,
6933*
7673,
6933*
7673,
6933*
CONNECT WIRING
Plug your steering servo plug into channel #1 of your receiver.
Plug your throttle servo plug into channel #2 of your receiver. (If your servos are
made by different manufacturers, then check your documentation to make sure
you don't have incompatibility problems.)
Plug your switch/receiver pack plug into the battery plug in your receiver.
Run the wires over the top of the transmission braces and secure it with a wire tie.
Route your wires neatly to prevent them from being damaged.
Attach your switch to the rear shock tower.
Attach the #7530 black foam pad to your rear bumper. Cut out the parts of the
foam pad where the wire ties are going to go.
Install your batteries into your receiver pack and place it into the rear bumper.
Install the two tie wraps around the receiver pack and through the bumper. Cut off
the excess.
7530
3720
7530, qty 1
black foam
6338
6338
