20
B A G O
REMOVE THESE
PARTS FOR:
Steps 1-3
T O O L S U S E D
s t e p 1
GAS ENGINE INSTALLATION
We can now install your standard format .12ci engine.
There are engines with displacements of .12 ci to .15 ci
which fit into the GT. If your engine is a standard .12
crank and side exhaust design it should fit into the GT.
WARNING! It is the responsibility of the buyer to verify
that the engine chosen will work in the GT.
Remove the carburetor from the engine. Loosen the nut
or clamp bolt behind the carburetor.
Use the wrench supplied in your motor box to loosen
your high speed mixture screw. Turn the valve
assembly until the fuel line fitting is facing the direction
shown, then retighten the valve assembly.
Attach one #7560 2-56 ball end and one #7560 2-56
plain nut into the lower hole in the throttle arm pivot. If
the hole is too small for the ball end, drill it out with a
#43 (.0890) or a 3/32 drill bit if you are careful.
WARNING! The throttle pivot arm is very small and can
be easily damaged. Use extreme care when drilling the
hole. We recommend using a threadlock on the threads
to keep the nut from coming loose due to engine
vibrations.
Reinstall the carburetor to the engine and tighten the
clamp nut or the mounting screws. You want to have
the carb perpendicular to the crankshaft.
7560, qty 1
ball end
1:1
7560
ball end
7560 nut
7560, qty 1
small plain nut
1:1
flywheel, qty 1
7610 (non pull start)
OR 7612 (pull start)
7618, qty 1
spacer (silver)
7618, qty 1
collet
1:1
7620, qty 1
cutoff nut
1:1
1:1
7603, qty 1
clutch nut
high speed
mixture screw
B A G N
REMOVE THESE
PARTS FOR:
Step 1
T O O L S U S E D
5407, qty 3
red O-ring
1:1
1/16"
7720, qty 1
fuel tank
7673, 6933*, qty 3
4-40 x 5/16 screw
1:1
MOUNT FUEL TANK
Push the #7673 (6933*) screws through
the bottom of the chassis and place a
#5407 red O-ring on each screw.
Push the #7720 tank onto the screws and
tighten the screws just enough to slightly
compress the O-rings so the fuel tank
cannot move around.
s t e p 1
7720
5407
5407
5407
5407
5407
5407
7673,
6933*
7673,
6933*
7673,
6933*
7617, qty 1
Picco spacer (gold)
1:1
OR
