S L I D E C A R B L I N K A G E S U P P L E M E N T A R Y S H E E T
PLEASE FOLLOW THESE STEPS IF YOU HAVE A SLIDE CARB
B A G O
REMOVE THESE
PARTS FOR:
Steps 1-2
T O O L S U S E D
.050", 3/32"
s t e p 1
7557, qty 1
throttle pivot
7558, qty 1
throttle pivot clip
7560, qty 1
throttle ball cup
7560, qty 2
throttle rod,
brake rod
7560, qty 4
collar
6951, qty 4
set screw
1:1
3721, qty
2-56 screw
1:1
7560, qty 1
spring
4118, qty 1
spring
7560, qty 1
washer
1:1
xxxx, qty 1
servo horn adapter
THROTTLE LINKAGE
Reverse the throttle servo so the output shaft is toward the front of the
truck.
Push the #7557 aluminum throttle pivot through the hole as shown.
Install the #7558 throttle pivot clip to the opposite side of the throttle
pivot. Push the clip against the adapter so that the clip's inner teeth flare
away from the adapter when fastened.
Cut off half of the threads on one end of your throttle rod.
Screw one #7560 ball cup onto the end of the rod. Slide on one #7560
collar about 5/16" from the ball cup, depending on what type of
carburetor you have have. Tighten it down with a #6951 set screw.
Cut the #7560 throttle spring in half with a pair of wire cutters. Slide the
spring on. Now slide the throttle rod through the throttle pivot, then slide
on and fasten the second #7560 collar on the rod. Tighten the collar
down on the rod next to the throttle pivot.
Attach the servo horn adapter assembly to your servo horn with the two
#3721 screws provided. See the photos for proper orientation of the
adapter to your stock servo horn.
Snap the ball cup onto the carburetor's ball end.
Cut off the remaining part of the throttle linkage with 1/4" remaining so
you can still adjust the throttle linkage later.
s t e p 2
BRAKE LINKAGE
Add a #7560 collar onto the second rod and secure it with
a #6951 set screw about 5/16" from the end of the threads.
Bend the brake rod according to the actual size drawing.
Cut the rod to length shown in the drawing.
Slide the threaded end of the rod through the brake disc
cam. Drop the bent end of the brake rod through the
adapter hole shown. Attach a #7560 collar with a #6591
set screw to the end of the rod underneath the adapter.
Slide on a #7560 washer, then the #4118 spring, then the
#7560 locknut. Tighten the locknut down until shown in the
photo at right.
1.90" (48.3mm)
5/16" (.30", 7.6mm)
cut remaining thread area
cut remaining wire
ACTUAL SIZE
3721
7558
6591
7557
6951
7560
7560
7560
7560
7560
3721
7560
toward
front
cut spring in half
7560
output
shaft
4.00" (101.6mm)
ACTUAL SIZE
7560
cut off end
5/16" (.30", 7.6mm)
7560
6951
7560
7560
6951
7560
4118
7560
7560
servo horn
adapter
