Assa Abloy Corbin Russwin SE LP10 9600 Series, Installation Instructions Manual

Page: 7 / 28

7
Installation Instructions
SE LP10 9600 Series Exit Device
With MELR
Copyright © 2020, ASSA ABLOY Access and Egress Hardware Group, Inc. All
rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
6) Wiring Diagrams
*Diagrams on following pages
Product 8 PIN CONNECTOR 4 PIN CONNECTOR
1-Black 2-Red 3-White 4-Green 5-Orange 6-Blue 7-Brown 8-Yellow 1-Violet 2-Gray 3-Pink 4-Tan
ACCESS CONTROL DEVICES: SE LP10 Mortise, ElectroLynx wire Color / Function assignments
SE LP10 12VDC
(Reader)
WIEGAND WIEGAND RX RX EGND TAMPER 12/24 VDC
(LOCK RELAY)
DPS DPS
GREEN_LED*
NEG POS DATA_1 DATA_0 NO COM EGND OPEN
COLLECTOR
NEG POS NC COM
INPUT
Default Operation Mode:
• Red LED ‘ON’ when powered.
• Presenting a 13.56MHz or 125 kHz credential causes LED to briefly turn green and then return to
red state.
• Presenting a FIPS 201 PIV credential causes LED to turn amber as credential is authenticated.
Reader emits a short beep when credential is successfully read. Reference Diagram #1.
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
Note: NC= Normally Closed
NO= Normally Open
PIN 8 (Yellow – TAMPER)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
PIN 8 (Yellow – Green LED)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Optional Alternate Indicator Mode:
Optional TAMPER Operation Mode:
• Connect Yellow TAMPER wire from ElectroLynx cable to desired EAC panel control line.
Reference Diagram #1.
• As appropriate, use the configuration card to activate desired mode on reader.
• Connect GREEN_LED input to switch controlled by panel. Shorting GREEN_LED to READER_NEG
(Black) with panel switch will override reader LED to keep it green.
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)