Ashida ADR111A, Instruction Manual

Page: 88 / 128

Doc ID : ADR111A_IM_01
Ref ID : ADR111A/IM/UG
Rev No. : 04
Page No. : 88 of 127
ADR111A /
ADR211A
No Legend Function
6.
LED RESET : Feather Touch Key LED RESET to Reset LED and HR Type Output contact
7.
+ /▲
: Feather Touch Key [ + ] Plus to INCREMENT the values &
[▲] to SCROLL the Main Menu up.
8.
-
/▼
: Feather Touch Key [ - ] Minus to 'DECREMENT' the values &
[▼] to SCROLL the Main Menu down.
9.
HW RESET : Feather Touch Key for HW RESET is provided for Hardware Reset. This key is
interlock with LED RESET key.
10. ► : Feather Touch Key [►] to VIEW the settings and to navigate through the menus
and submenus.
11.
USB : USB port for serial communication. (For ADR211A only)
12.
LCD Display : 16 x 2 char. LCD display to observe settings and parameters of the relay.
8.1 USER INTERFACE
8.1.1 LCD Display
Back-lit LCD display 16 x 2 characters is provided for the parameter and setting display,
and for easy viewing of measurement, setting, fault records, date & time and error
message. Back-lit will automatically switch OFF if any key is not pressed for more than
100sec. Back-lit is also automatically turned ON when any tripping occurs.
8.1.2 Touch Keys
The function of relay is controlled by the following keys provided on the Front Plate:
(

) Left Arrow: Left Arrow key (

) is used to navigate through the menus and SAVE
settings.
(+ /
▲) Plus / Up Arrow: (+) Plus is used to increment the setting value in the display. The
(
▲) Up Arrow is used to scroll the menu in UP direction.
(

) Right Arrow: The Right Arrow key is used to VIEW the settings and to navigate
through the menus.
LED RESET: The Key for Reset LED and HR type Output contact
(- /

) Minus / Down Arrow: (-) Minus is used to decrement the setting value in the
display. The (

) Down Arrow is used to scroll the menu in DOWN direction.
HW RESET: The ‘HW RESET’ key is not required in normal operation but it is used to
reset total hardware of relay. This key is interlocked with LED RESET key. This is
normally required during firmware update of relay.