Artesyn ATCA-7360, Installation And Use Manual

Page: 57 / 288

Installation
ATCA-7360 Installation and Use (6806800J07S)
57
3. Insert the DIMM module carefully into the socket.
As soon as the memory module has been fully inserted, the locks get closed
automatically.
4. If applicable, repeat steps 2 to 3 to install further modules.
Removal Procedure
To remove a DIMM module, proceed as follows:
1. Remove the blade from system as described in Installing and Removing the Blade on
page 60 .
2. Open the locks of socket at both sides.
The memory module is automatically lifted up.
3. Remove module from the socket.
4. Repeat steps 2 to 3 in order to remove further memory modules.
2.5.2 PMEM and SATA Module
The PMEM/SATA extension slot allows assembly of either a PMEM or SATA module which are
available as upgrade kits for ATCA-7360. PMEM module consists of an SRAM and a flash
memory. The SRAM has a capacity of up to 16 MB and can be used as persistent memory, that
means a memory that holds up the contents during reset. The flash memory has a capacity of
up to 64 MB organized as two memory banks. The S/F memory module connects to the blade's
PCI subsystem. It can be configured via an FPGA register.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.