Artesyn ATCA-7360, Installation And Use Manual

Page: 215 / 288

Serial Over LAN
ATCA-7360 Installation and Use (6806800J07S)
215
Default Gateway MAC : 00:00:00:00:00:00
RMCP+ Cipher Suites : 1,2,3,3
Cipher Suite Priv Max : Not Available
root@localhost: ~#
7.4 Establishing a SOL Session
To start a SOL session the following requirements must be fulfilled:

An Ethernet LAN connection to the 82576 controller of the ATCA-7360 must exist.

ATCA-7360 IPMC FW must correspond to version 2.00.7 and above.
Procedure
To establish a SOL session, proceed as follows.
1. Make sure that the requirements detailed above are fulfilled.
2. Compile and install the ipmitool on your target which is destined for opening the
SOL session on the ATCA-7360 - for details refer to Installing the ipmitool on page
211 .
3. Apply an IP address to the ATCA-7360 SOL interface - for details refer to Configure
SOL Parameters on page 212 .
4. If necessary change user and password.
Defaults are "soluser" as user and "solpasswd" as password.
5. Configure the network between the ATCA-7360 and your target, which is destined
for opening the SOL session, so that the SOL IP address is accessible.
MAC Address 00:00:00:00:00:00 means the address is shared between base and SOL
interface. The address can be found out in the MAC address record of the FRU.