Artesyn ATCA-7360, Installation And Use Manual

Page: 244 / 288

Supported IPMI Commands
ATCA-7360 Installation and Use (6806800J07S )
244
8.4.5 Set Debug Level Command
The Set Debug Level command sets the current debug level of the IPMC firmware.
5 Bit [7] IPMB-L Dump Enable
If set to 1, the IPMC provides a trace of IPMB-L messages
that are arriving to/going from the IPMC via IPMB-L.
Bit [6] n/a
Bit [5] KCS Dump Enable
If set to 1, the IPMC provides a trace of KCS messages that
are arriving to/going from the IPMC via KCS.
Bit [4] IPMB Dump Enable
If set to 1, the IPMC provides a trace of IPMB messages that
are arriving to/going from the IPMC via IPMB-O.
Bit [3] n/a
Bit [2] Alert Logging Enable
If set to 1, the IPMC outputs important alert messages onto
the serial debug interface.
Bit [1] Low-level Error Logging Enable
If set to 1, the IPMC outputs low-level error/diagnostic
messages onto the serial debug interface.
Bit [0] Error Logging Enable
If set to 1, the IPMC outputs error/diagnostic messages
onto the serial debug interface.
Table 8-29 Get Debug Level Command (continued)
Type Byte Data Field
Table 8-30 Set Debug Level Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00