Arjohuntleigh Maxi Sky 2, Maintenance And Repair Manual

Page: 22 / 140

4 - 10
- Standard tool kit
- Torx T20 screwdriver
- Extractor Pin (P/N: 005.00374)
- Extractor Pin Amp (P/N: 001.00001)
- Extractor Pin Amp Mini (P/N: 001.00002)
SUGGESTED TOOLS
RECOMMENDED SPARES
For Maxi Sky 2 - refer to the PARTS LIST 001-15699-EN
For Maxi Sky 2 Plus - refer to the PARTS LIST 001-31230-EN
RISK ASSESSMENT CHECKLIST FOR TECHNICIANS
IF IN DOUBT, CONTACT YOUR LOCAL ARJOHUNTLEIGH
REPRESENTATIVE. DO NOT TAKE UNNECESSARY RISKS
WARNING
The following assessments MUST be done before carrying out service, repair works or installations:
- Immediately stop.
- Make sure the work area is adequately sized, suitably lit and at a reasonable temperature.
- Use safe work and handling practices to keep risks of injury to a minimum.
- Tools and equipment must be kept in good condition.
- Wear protective clothing, shoes and eye protection when necessary.
- When you are handling an electronic component of the Maxi Sky 2 you must be ESD protected.
- You should be adequately trained to perform a task.
- Do not manually lift items that could cause personal injuries and that are too heavy, hot or sharp.
- You must comply with all local site safety rules, report any incidents or accidents to the site safety supervisor or
equivalent. Use the ArjoHuntleigh reporting procedure.
- Load tests must only be done as instructed in the relevant procedures.
- If it is necessary to work from a platform (i.e. scaffold, ladders, etc.) to perform a service or installation task make
sure the platform is secure and suitable for the task.
SHUT OFF THE POWER BEFORE SERVICING BY PULLING
ON THE RED EMERGENCY STOP CORD
DANGER
- Do not perform maintenance tasks on equipment with “live” electrical connections unless it is absolutely necessary.
- Isolate the power supply before removing plugs, sockets or disconnected cables.
- Be alert at all times to the dangers of working on electrical equipment that operates on mains supply voltage.
Where possible, visually inspect electrical cables, plugs, etc. for damage or deterioration before working on equipment.
- Dispose of all waste in appropriate containers, in compliance with local legislation.
001-15697 rev
. 5