Ardo CDR07SU, Manual, Page: 20 / 168

18
SM2164
USING THE DRIER
GB
DESCRIPTION OF THE CONTROL PANEL.
P. Programmer knob. Used to select the required
programmes according to the types of fabrics
and their specifi c needs. If, for any reason, you
want to change the programme or add more
washing to the load during the drying cycle,
simply place the programmer knob in the
"STOP" position. Then re-position the knob on
the required program and press the "START"
button.
NB. Warning!! Only use this function if strictly
necessary and then only if the programme
to reset has been running for less than 3
minutes.
S. Start Button. Press this button to start the
programmed drying cycle.
L
S
. Start Led. Off indicates the "STOP" position.
On fi xed indicates the cycle is running. Fast
fl ashing indicates the set programme is ready
to start. Slow fl ashing indicates the end of the
drying programme.
V. Water reservoir alarm reset button. Used to
restart the cycle after the condensation water
reservoir has been emptied (fi g. 11)
L
V
. Reservoir full alarm Led. A flashing light
indicates that the reservoir is full and needs
to be emptied (the drying cycle stops). After
the container has been replaced, a fi xed light
indicates that the function is restarting. Light
off indicates that the alarm has been reset (the
cycle restarts).
A. Anti-crease button. Activates a function that,
at the end of the drying cycle, rotates the drum
and the washing loaded in it in one direction then
in the other for a further sixty minutes to reduce
creasing. Each rotation is signalled by a short
beep.
L
A
. Anti-crease Led. Off indicates that the function
has been disabled. A fi xed light indicates that
the anti-crease function is active. A fl ashing light
indicates that the function is running. When the
drying cycle is over, the start Led will also light
up and fl ash slowly.
C. Beep silencer button. Disables the beep
function, which would otherwise be permanently
enabled.
L
C
. Beeper Led. Off indicates that the beeper
is enabled, on indicates that the beeper is
disabled (the selection remains memorised
even when the appliance is switched off).
R. Delayed start button. Used to delay drier
start-up for up to a maximum of 8 hours. The
delay in hours can be selected as follows: each
time the button is pressed, the drying cycle is
delayed 1, 2, 4 and 8 hours. When the START
button is pressed, the selected led will fl ash
signalling that the function has been activated.
The machine will wait for the number of hours
set to elapse and then start the drying cycle
automatically.
If the power supply is interrupted while the
delayed start function is active, the function
itself will be annulled. Pressing the start button
will start the drying cycle immediately.
L
R
. Delayed start Leds. These light up one at a
time. A fi xed light indicates the set time delay.
A fl ashing led indicates that the delayed time
function has been activated. The led switches
off when the set time delay has elapsed.
L
R
L
A
L
C
L
V
L
S
R C A V S
40’
120’
30’
40’
60’
80’
100’
120’ 30’ 50’
70’
90’
110’
130’
150’
170’
60’
40’
60’
120’
P
9
Model with timer controlled
drying