Arctic Cat VLX 70002017, Service Manual

Page: 95 / 138

94
1. Set the meter selector to the Diode position.
2. Connect the red tester lead to the orange/white wire;
then connect the black tester lead to the yellow/green
wire.
3. With the starter button depressed, the meter must
show 0.5-0.7 DC volt.
4. With the starter button released, the meter must show
.OL.
5. Connect the red tester lead to the yellow/green wire;
then connect the black tester lead to the orange/white
wire.
6. With the starter button depressed, the meter must
show .OL.

NOTE: If the meter does not show as specified,
replace the switch.
RESISTANCE (Engine Stop Switch)
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to the orange wire; then
connect the black tester lead to the orange/white
wire.
3. With the switch in the OFF position, the meter must
show an open circuit.
4. With the switch in the RUN position, the meter must
show less than 1 ohm.

NOTE: If the meter shows more than 1 ohm of resis-
tance, replace the switch.
RESISTANCE (Reverse Override)
The connector is the four-prong white one next to the
steering post. To access the connector, the front rack and
front fenders must be removed (see Steering/Body/Con-
trols).
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to one red/yellow wire;
then connect the black tester wire to the other
red/yellow wire. The meter must show less than 1
ohm.
3. Depress and hold the reverse override button. The
meter must show an open circuit.
4. Connect the red tester lead to the blue wire; then con-
nect the black meter lead to the black wire. The
meter must show an open circuit.
5. Depress and hold the reverse override button. The
meter must show less than 1 ohm.

NOTE: If the meter does not show as specified,
replace the switch.
RESISTANCE (Gear Position)
The gear position switch is located on the engine/trans-
mission next to the shift arm.
FI525B
1. Disconnect the gear position switch connector; then
using a multimeter, test the switch in each position as
follows. Resistance must be less than 1 ohm for all
tests.
KC410A
A. Neutral (N)Pins 3 to 4
B. Reverse (R)Pins 3 to 4 and 3 to 2
C. High (H)Pins 3 to 4 and 3 to 1
D. Low (L)Pins 3 to 1
2. Connect the harness to the gear position switch.
Fan Motor
The connector is the black two-prong one located above
the oil cooler/radiator.
Component data can be retrieved using the CATT II. Uti-
lize the Sensor Data screen.
Component data can be retrieved using the CATT II. Uti-
lize the Sensor Data screen.
This component can be tested using the CATT II. Utilize
the Test screen.