Arctic Cat VLX 70002017, Service Manual

Page: 107 / 138

106
High: A high voltage condition has been detected
Low: A low voltage condition has been detected
Intermittent: An intermittent circuit condition has been detected
Open: An open circuit condition has been detected * After correcting the condition, cycle the key switch On-Off-On
**After correcting the condition, cycle the key switch On-Off-On,
start the engine, then cycle the key switch On-Off-On.
P0485 Fan-Primary/Right Relay Control Circuit
Low/SG/Open Primary fan fuse has blown, the primary fan relay has been removed
or interconnect harness shorted to chassis ground Correct condition*
P0500 Vehicle Speed-Sensor Sensor circuit signal intermittent or missing Correct condition*, start
and drive the vehicle*
P0508 IAC System Circuit Low/SG IAC interconnect harness shorted to chassis ground Correct condition*
P0509 IAC System Circuit High/Open IAC disconnected or the interconnect harness shorted to battery
power Correct condition*
P0562 System Voltage Low Battery charge condition low or the regulator/rectifier output low Correct condition*
P0563 System Voltage High Battery cable connections are loose or the regulator/rectifier output
high Correct condition*
P0601 ECM CAN Communication Shutdown Intermittent CAN connection or unstable CAN condition caused ECM
to temporarily shut down CAN communication Correct CAN
communication issue*
P0615 Starter Relay Circuit Start switch/button, starter relay, gear switch or interconnect harness
erratic or intermittent Correct condition*
P0616 Starter Relay Circuit Low Start switch/button, starter relay or interconnect harness intermittent
or shorted to chassis ground Correct condition*
P0617 Starter Relay Circuit High Start switch/button, starter relay or interconnect harness intermittent
or shorted to battery power Correct condition*
P0630 VIN Not Programmed or Incompatible Verify the Indicator Display and ECM part numbers are correct for the
vehicle model number and VIN Correct Indicator Display
and ECM VIN compatibility
issue*
P0642 Sensor Power Circuit Low One or more of the sensors defective or shorted to chassis ground Correct condition*
P0643 Sensor Power Circuit High One or more of the sensors defective or shorted to battery power Correct condition*
P2300 Rear Ignition Coil Primary Circuit
Low/SG/Open Coil or interconnect harness open or shorted to chassis ground Correct condition**
P2301 Rear Ignition Coil Primary Circuit High Coil or interconnect harness shorted to battery power Correct condition**
P2303 Front Ignition Coil Primary Circuit
Low/Open Coil or interconnect harness open or shorted to chassis ground Correct condition**
P2304 Front Ignition Coil Primary Circuit High Coil or interconnect harness shorted to battery power Correct condition**
P2531 Ignition Switch Circuit Low Battery charge condition low or the regulator/rectifier output low Correct condition*
P2532 Ignition Switch Circuit High Battery cable connections are loose or the regulator/rectifier output
high Correct condition*
U0155 Indicator Display to EFI ECM CAN
Communication Lost Indicator Display CAN circuit or interconnect harness intermittent or
has failed Correct condition*
U1000 Vehicle Not Registered or Invalid PIN
Entered An invalid registration PIN has been entered Enter the correct
registration PIN*
U1001 Vehicle Not Registered and Vehicle Limits
Enabled An invalid registration PIN has been entered Enter the correct
registration PIN*
FUEL OFF Tilt Sensor Activation Code Sensor has been activated Restore the vehicle chassis
to an upright position*
Code Fault Description Possible Cause Fault Recovery Method