79
H2-004
3. Zero the indicator and rotate the crankshaft slowly.
4. Maximum runout must not exceed specifications.
NOTE: Proceed to check runout on the other end of
the crankshaft by positioning the indicator contact at
point 2 and following steps 3-4.
Measuring Crankshaft
(Web-to-Web)
1. Using a calipers, measure the distance from the out-
side edge of one web to the outside edge of the other
web.
H2-005
2. Acceptable width range must be within specifications.
COUNTERSHAFT
GZ281A
Disassembling
1. Remove the shift forks noting the positions for assem-
bling; then remove the high driven gear outer washer,
high driven gear, high driven gear bearing, high driven
gear bushing, and high driven gear inner washer.
GZ283A
2. Remove the drive gear; then remove the snap ring
securing the reverse driven gear dog and bushing to
the countershaft.
GZ296
CAUTION
Care should be taken to support the connecting rod
when rotating the crankshaft.
CAUTION
When disassembling the countershaft, care must be
taken to note the direction each major component (dog,
gear) faces. If a major component is installed facing the
wrong direction, transmission damage may occur
and/or the transmission will malfunction. In either case,
complete disassembly and assembly will be required.
