26
EPS008A
EPS007
3. Install the tie rods and secure with the slotted nuts.
Tighten to 30 ft-lb; then install new cotter pins.
NOTE: If the slots do not align with the holes in the
tie rod ends, tighten the nuts just enough to allow
installation of the cotter pins.
AF778D
EPS005A
4. Connect the 2-pin and 8-pin connectors to the EPS
assembly.
5. Install the upper steering post support to the frame
and secure with two cap screws. Tighten to 20 ft-lb.
6. Install the storage compartment, steering post and
radiator access panels, and storage compartment
cover; then install the shock absorber and tighten to
50 ft-lb.
7. Install the front wheels and tighten the nuts to 40
ft-lb (steel wheels) or 80 ft-lb (aluminum wheels).
Handlebar Grip
REMOVING
1. Loosen but do not remove the cap screws in the end
of the handlebar; then tap lightly on the head to dis-
lodge the handlebar plug.
KC310
KC309A
2. Grasp the end and remove the cap screw, plug, and
end cap.
INSPECTING
1. Inspect the grip for wear, cuts, or cracks.
2. Inspect the grip for deterioration.
3. If a grip is damaged, cut the grip lengthwise using a
sharp knife or box cutter; then peel off the grip.
