23
4. Inspect for missing decals.
INSTALLING
1. Remove the gas tank cap and set the rear body panel
in position; then install the cap and connect the tail-
light/brakelight connector.
2. Place the rear rack in position with the bushings and
secure with the cap screws and lock nuts. Tighten
securely.
3. Install one shoulder screw and three plastic rivets (on
each side) to secure the front of the rear body panel
to the footwells.
CD691
4. Place the battery into the battery box; then connect
the battery (positive cable first) and secure with the
battery cover.
CD687A
5. Secure the front and rear panels with two machine
screws; then install the left and right side panels.
NOTE: If the front body panel has not been
installed, see Front Body Panel/Side Panels in this
section.
6. Place the seat into position making sure it locks
securely.
LCD Gauge
REPLACING
To replace the gauge, use the following procedure.
1. Remove the two reinstallable rivets securing the
instrument pod; then remove the ignition switch
retaining ring.
2. Remove the two nuts securing the mounting studs;
then remove the gauge and disconnect the
multi-pin connector.
3. Mount the gauge and secure with the two nuts;
then connect the multi-pin connector.
4. Install the instrument pod and secure with the rein-
stallable rivets.
5. Secure the ignition switch with the retaining ring.
Steering Post/Tie Rods
REMOVING
1. Remove the ignition switch retaining ring; then
remove the reinstallable rivets securing the instru-
ment pod to the mounting bracket and remove the
pod and LCD gauge.
FI463A
FI464A
2. Remove the reinstallable rivets securing the radiator
access cover and remove the cover.
