05/10/11
Page 16 of 21
378 7983
50. Adjust the bull bar position up/down
and in/out to achieve uniform gaps
between the bar and the fenders on
each side of the vehicle. The nominal
clearance between the bull-bar and the
fenders is 20mm. Firmly tighten the
bolts fitted at step 46.
Once satisfied with the position of the bull-bar,
using a 10mm drill, drill through the 10mm
holes in the impact absorber, 2 holes per side,
and secure using the M10 x 30 bolts, two flat
washers per bolt, spring washers and hex
nuts.
51. Fasten the chassis-stiffening bracket to
the chassis and the impact absorber as
shown. Fasteners required include: six
M10 x 35 bolts, twelve M10 flat
washers, six M10 spring washers, six
hex nuts
Leave this bolt hole clear for step 54.
