05/10/11
Page 12 of 21
378 7983
30. Remove the cover from the control box.
31. Replace the three main power cables
that go from winch to control box. Make
sure that you identify the colour codes
on the new cables before closing
control box cover.
32. This must be done for whatever winch
is to be fitted to the bull bar.
33. If fitting the XP 9.5 winch, remove the
cover from the control box, otherwise
proceed to step 36.
Remove the two cap screws, nuts and
spacer washers that hold the four
solenoids in place.
34. Remove the four solenoids from the
base of the control box using the
copper bus bar as an aid and hold to
one side.
