05/10/11
Page 9 of 21
378 7983
20. Fit the buffers to the bull bar using the
6mm flange nuts provided.
(DO NOT OVER TIGHTEN)
21. Fit cage nuts and nylon plugs to the
bull-bar.
M10 cage nuts. (4 off) Caged portion is to
centre of bull bar.
M8 cages nuts. (4 off) Caged portion is to top
of bull bar.
22. Remove the fastening screws and nuts
supplied with the turn signal/clearance
lamps and replace these with the four
screws provided in the kit. Push the
square plastic plugs into the holes on
the turn signal bracket. Fasten the turn
signal lamps to the bull bar as shown.
NOTE: - The drain holes in the lamp are at the
bottom. (As shown)
IMPORTANT: -
The turn signal (amber section) is to face to
the inside of the bull bar.
Drain Holes
