05/10/11
Page 13 of 21
378 7983
Before
35. Remove the two bolts in the base of the
control box and reposition them into the
more centralized holes.
After
36. Place the 4 solenoids over the 2 metal
stands that are facing upwards. Make
sure they line up with the holes in the
base.
37. Replace the 2 cap screws, washers
and nuts removed in step 14 above into
original holes.
Replace the black cover and refit the three cover
screws. (DO NOT OVER TIGHTEN)
38. Bolt the control box bracket to the
control box.
39. Fit the two grommets into the round
holes in the top of the bull bar then
thread the cables through.
40. Mount the control box bracket onto the
top pan, using M8 bolts, flat washers
and flanged nuts. Use the cable ties to
ensure the winch cables are secure,
clear of moving parts and sharp edges
and tie them together.
