05/10/11
Page 10 of 21
378 7983
23. Fit the factory fog lamp to the bull bar
bracket by engaging the peg on the fog
lamp (right hand side shown) into the
hole in the out board (shorter) side of
the bracket as shown.
24. Align the black clip located at the back
of the lamp into the corresponding hole
in the bracket.
Push the inner edge of the fog lamp into the
bracket to fully retain the fog lamp.
25. To ensure a tight fit of the fog lamp into
the bracket bend the tabs on the
bracket in towards the lamp with a
screwdriver.
Repeat this on the other side.
NOTE: - If the removal of the fog light is
necessary pry the tabs outward from the
lamp and using a screw driver between the
body of the lamp and bracket on the inner
(longer) side of the bracket flex the bracket
to disengage the fog lamp post from the
bracket
.
26. The fog lamp surround is held to bar
using silicon adhesive. Apply a bead of
silicon adhesive around light cut out on
the bull bar and hold the fog light
housing to the bull bar using masking
tape until the silicon adhesive dries,
then remove the tape.
