05/10/11
Page 5 of 21
378 7983
ASSEMBLY SEQUENCE FOR BULL BAR INSTALLATION.
1. Remove existing bumper and grill from
the vehicle.
Once these are removed:
-
Remove the light bracket fitting and
discard; this is done by first removing
the light and then unscrewing the
bracket from the rear of the light fitting.
-
Remove the bumper braces and
discard.
-
Remove the chassis cross-brace and
discard.
-
Remove the factory fog lamps from the
bumper bar and keep aside.
2. Remove the plastic bumper retention
blocks from either side of the vehicle.
3. Replace the front most screws (these
secure the head lights).
4. Spray paint the metal underside of the
fender and the underside of the
headlamp black.
Ensure the area to be painted is well
masked to ensure no over spray on other
components.
